For comfortable operation of the H42 Communicator in vehicle, Docking station is used. It gives the user the possibility to adjust the operation angle and to connect directly to the car power and communication system. With the optional embedded GPS* module, it enables   location tracking of the vehicle. The communicator as well as the docking stations comply with the regulation for in-car use of electrical devices – EEC type-approval cerificate (E1).  



   Docking Station


 
Robust Docking Station (DS) complements Gotive communicator, either in the car or on the desk. It was designed for secure communicator holding and intelligent charging while providing maximum communication and functional features and options, including USB-A,
USB-B, RS232, 2xAudio Connector, embedded GPS* option, GSM/GPRS/GPS connectors for external antennas, rugged Vehicle Cable connector, or programmable Action Keys and E - Lock (Electrical Locking system).
  






      Key Hardware

       Voltage regulator
       INPUT: 9-40 V=; max. 20W; OUTPUT 5V=+-5%, 3A
     
       USB HUB
       Full Compliance with USB Spec Rev 1.1; Four Downstream Ports (one engaged,
       one internal useable for Serial module, two on USB - A connectors)


       Dual USB UART
       One UART engaged by Microcontroller (AT90CAN128); one UART for GPS module

       Audio amplifier
       STEREO 2-W/Ch Output

      Communications/Interfaces

       USB
       Host via 2x USB A connectors, USB 1.1
       Client via USB B connector, USB 1.1/2.0 Full Speed

       12-pin Vehicle Cable Connector
       CAN (Controller Area Network). Fully Compliant with CAN Standard rev 2.0 A and rev 2.0 B
       Power Input
       2x digital input
       Mono audio output
       External Microphone

       Power
       INPUT: 9-40 V DC Power Jack (2.5mm inner pin dia.)

       Buttons
       4 x programmable DS action keys

       LED indicators
       Power, System status

       Headset
       2.5mm Stereo jack

       Stereo audio output
       3.5mm Stereo jack

       GSM/GPRS (optional)
       H42 GSM/GPRS External Antenna connector

       GPS* (optional)
       H42 GPS External Antenna connector
       H42 DS GPS External Antenna connector

       Serial module (optional)
       "2x RS232 (2x DB-9/M connectors) with full Handshaking & Modem interface signals; supports
       7 / 8 bit data, 1 / 2 stop bits, and Odd / Even / Mark / Space / No Parity; Transfer Data Rate 300
       to 250kbps"

       GPS module (optional)
       Ultra-low power GPS receiver module with built-in low noise amplifier designed for active
       antennas

       Electronic lock (optional)
       controlled by software in H42 terminal

       Mechanical lock (optional)

* availability will be announced
For embedded options availability and combination scheme refer to valid pricelist or contact your nearest distributor.